"TILT the embedded ethernet playing field in your favor"

This is legacy product information, retained for support purposes only. Please see the current TStik TINI400 product information at http://www.tstik.com/

Click here for a detailed sockets board feature comparison


TILT390
TILT is complete with power regulator, reset button, DTR jumper, iButton clip and more. CAN driver version too (shown below)!


MORE PHOTOS
 

We were challenged to create a low cost, basic sockets board for TINI 390 module - our answer is the TILT* board.

Now shipping in a SIMM72 version (and we still have a few SIMM68 left). Optional CAN interface (shown in the photo) and twisted pair driver chip for Control Area Network.

TILT is a standard Euroboard 100x100 mm. All it requires is 6-9 VDC unregulated. Low cost panel and DIN rail mounting kits also available.

If you need more features, expansion, and a prototype area, "step" up to STEP.

*TILT (tm) Systronix.Please order TILT on-line in our secure web store.

Try our demo TINI system, running on a Systronix socket board.

Datasheets & Manuals (use Acrobat reader 4.X for best results)

TILT board layout (100 KB) Rev 3 board layout
TILT schematics Rev 3 (200 KB) Rev 3 schematics (with 5x2 header for CAN)
TILT schematics Rev 1 (200 KB) Rev 1 (with CAN screw terminals)

TILT versions, issues and errata
Please read this before you purchase

Get the free Acrobat reader from Adobe. Supports all major computer platforms.

TILT FEATURES

  • SIMM72 socket for current versions of TINI.
  • High quality SIMM socket with metal latches
  • single RS232 serial from TINI primary RS232, DB9F
  • optional CAN net with 82C25X twisted pair driver. TILT.XX.CAN includes CAN cable driver and board connector. TILT.72.CAN uses a 5x2 receptacle to DB9M cable and conforms to the CANOpen DB9 pinout. For development, boards can be networked with 5x2 IDC receptacles along a length of common ribbon cable.
  • Clip on TINI external 1-wire net accepts an iButton and uses Dallas drivers
  • RJ11 on TINI external 1-wire net accepts Blue Dot receptors or long 1-wire lines and uses Dallas drivers
  • Ethernet RJ45
  • rugged linear power supply, 6-9 VDC input, 5.5 x 2.5 mm jack, center positive
  • reset switch
  • DTR jumper (controls TINI reset via serial port DTR line)
  • 100x100 mm EuroBoard size fits standard enclosures including those from Systronix.
  • Optional 6VDC 800mA US plug AC adapter, UL/CSA listed
  • Optional 6-inch ribbon cable with 5x2 receptacle one end, CAN Open DB9M other end.